Start with the label beside the photo. A scalp scan captures a patch of skin and the hairs emerging from it. Knowing where and when the picture was taken helps you decide what a change on screen means for your own care.

At TTE Elephant in Mid Valley City, KL, and Eco Botanic, Iskandar Puteri, our AI scalp analysis takes 10–15 minutes, covers ten scalp zones and includes a written report. The scan is complimentary with a treatment. Here is how to read a computerised scalp analysis with your therapist.

Read the site, date and units

Find the scalp zone. A picture of the crown catches the whorl where your hair changes direction. A temple image frames a different part of the hairline. Ask the therapist to mark the site on your report so you can find it again.

A therapist holds a scanner against a parted section of hair while the monitor shows the magnified area.
Fig: A therapist holds a scanner against a parted section of hair while the monitor shows the magnified area.

Check what was counted. Hair density usually means the number of individual hairs per square centimetre. If the units say “follicular units/cm²”, the device is counting groups of hairs that emerge together. A group may contain several hairs, so those two counts answer different questions.

Look at strand size separately. Hair thickness in a scan usually describes the diameter of one shaft, often in micrometres (µm). Two patches with similar hair counts can look different if one has finer strands. If a report gives only a score, ask what the number measures and which image it came from.

Illustration comparing hair density, measured in hairs per square centimetre, with the diameter of one hair shaft, measured in micrometres.
Fig: Illustration comparing hair density, measured in hairs per square centimetre, with the diameter of one hair shaft, measured in micrometres.

Walk through an example

Suppose the note beside a crown image reads “fine white flakes near the parting”. You last washed yesterday and used dry shampoo this morning. Record both details beside the image. Product residue and scale can look similar under magnification. If that spot has itched for a fortnight, record that too. Your therapist can use the observations to discuss a comfortable cleanse. Identifying the cause of persistent itching takes a clinical history and examination.

Keep that first labelled image as your baseline. At a later visit, ask for the same spot, magnification and lighting, with a similar interval since washing. Compare images taken before cleansing on both visits. A photo taken immediately after a rinse can show that surface flakes washed away. You would need to see how the area looks and feels between washes to tell whether the flaking has settled.

Questions about your scalp report

Q: Should I wash my hair before the scan?

A: Ask the branch about preparation when you book. Note when you last washed and which scalp products you used afterwards. Washing can remove surface scale, and products can leave traces in a magnified image.

Q: Who should interpret a scan if I have a new bald patch?

A: Arrange a dermatologist appointment for a new patch of hair loss, persistent scalp pain or worsening shedding. Bring the dated images and a note of when the change began. A dermatologist can examine your scalp, review your history and decide whether blood tests or a scalp biopsy would help establish the cause.